|
Step 2 for Standard Riser |
Layout the Riser
Layout the pieces of your standard pedestal inside the frame as
pictured. The finished sides when assembled will face outside. These are
often painted black. |
Brackets
Slide the plastic corner brackets into each corner of the pedestal base.
Slide the corner bracket in at an angle to start, for easier assembly. |
Brackets Close-up
Firm pressure is usually required to slide the corner brackets on. Do
not use a hammer. |
Supports
Assemble the two sets of the center support system by inserting the
slotted pieces into each other. Position the two sets of center supports
in the cnter of the bed head to foot and side to side.
Alternately you may receive a single long support with two shorter
supports. Position it down the middle of the pedestal base. |
Center it again
The pedestal should be accuratly centered inside the frame. Use a tape
measure to ensure accuracy. |
Remove the Frame
While not disturbing the pedestal, tilt one side of the frame up and let
it rest on its side. This is so you can place the decking boards on top
of the pedestal.
Step not required for many four post models. |
