|
Step 6 Liner |
Spread It Out
Spread your safety liner out in the frame. Smooth out all wrinkles
particularly over the heating pad. Align all corners of the liner with
the frame's corners. |
Stand-Up Style
If you purchased a stand-up safety liner, it's simple to install. Spread
it out and smooth out all wrinkles particularly over the heating pad. |
Optional Duvet/Protective Cover
If you purchased an optional duvet, this is the point where it would be
installed. Be sure that the manufacturers label is at the foot of the
bed. Unfold the duvet and lay it out similar to the way the safety liner
was laid out.
Unzip the duvet down both sides and lay it over the head of the bed.
This allows easy access for installing the waterbed mattress(s). Smooth
out the inside of the duvet. |
Get Duvet Ready
Unzip the duvet (if applicable) on both sides and lay it over the head
of the bed. This allows easy access for installing the waterbed
mattress(s). Smooth out the inside of the duvet.
Take care with the zippers, too much stress and they will pull apart
possibly causing damage. |
Mattress
Lay out your waterbed mattress. Be sure the fill valve is at the foot of
the mattress. Be careful not to shift the fiber layers inside the
mattress as you maneuver it around. You also need to be sure the safety
liner stays in place. Remove the wrinkles on the mattress bottom and
center it.
Do not tape the safety liner to the frame, this often results in a
ripped safety liner. |
Aligning It Is Important
Gently align the corners of the mattress with the corners of the frame.
Check the heater, heater sensor tube, and safety liner for proper
position before moving on to the next step. |
